Cycling Intensity Workout

Wednesday Windtrainer Workout: No Limits Bike Intensity Session I

Threshold training doesn’t always have to mean sitting at one constant power for a long interval.

Sometimes, gradually increasing the intensity can create a very different challenge.

No Limits Bike Intensity Session I uses three progressive eight-minute ramps. Each ramp consists of four two-minute stages, with the intensity increasing every two minutes. More importantly, each complete ramp starts and finishes harder than the one before it.

The first builds from Level III to Level IV.

The second starts at Level III+ and finishes at Level IV+.

Then the third begins at Level IV- and eventually takes you into Level V-.

That progressive structure gives you plenty of quality work around threshold while repeatedly asking you to respond to another increase in intensity.

Build the intensity. Control the power. Finish above threshold.

Session Inspiration

This workout was inspired by a session from Maria Simone of No Limits Endurance Coaching. You can read the full article here.

What initially appealed to me was the progressive nature of the workout.

Rather than simply prescribing three identical intervals, the entire intensity range moves upwards as the session develops.

During Ramp #1, you progressively work your way towards threshold.

Ramp #2 begins harder and takes you above it.

Then Ramp #3 begins close to threshold and eventually finishes at Level V-.

It’s a straightforward progression on paper, but accurately executing each increase becomes increasingly challenging as fatigue accumulates.

Today’s Workout

Warm-Up

  • 15min Level I
  • 5x:
    • 30sec Level IV
    • 30sec Level I Rest Interval
  • 2min Level I

Begin with 15 minutes of easy Level I riding.

Then complete five short 30-second Level IV efforts, each followed by 30 seconds at Level I.

These aren’t intended to be exhausting. They introduce some intensity, increase your readiness for the main set and give you several opportunities to transition cleanly from easy riding into Level IV.

After completing all five, ride another two minutes at Level I before beginning the first ramp.

Main Set

The main set consists of three eight-minute ramps.

Each ramp contains four two-minute stages, with the intensity increasing every two minutes.

Ramp #1

  • 2min Level III
  • 2min Level III+
  • 2min Level IV-
  • 2min Level IV

Then:

  • 5min Level I Rest Interval

Ramp #2

  • 2min Level III+
  • 2min Level IV-
  • 2min Level IV
  • 2min Level IV+

Then:

  • 5min Level I Rest Interval

Ramp #3

  • 2min Level IV-
  • 2min Level IV
  • 2min Level IV+
  • 2min Level V-

After completing the final two minutes at Level V-, move straight into the cool-down.

There is no additional Rest Interval after Ramp #3.

Cool-Down

  • 10min Level I

Bring the intensity right down and allow your legs to gradually recover with ten minutes of easy Level I riding.

Stretching

  • 10min stretching

Why You’re Doing This Session

The defining feature of this workout is the progressive increase in intensity.

During each eight-minute ramp, you hold an intensity for two minutes before increasing the workload.

That means you never really get an opportunity to settle into one power for long.

Just as you become accustomed to the current intensity, it’s time to produce a little more.

Then a little more again.

What makes the workout particularly effective from a coaching perspective is that the progression occurs on two levels.

First, the intensity increases within each individual ramp.

But the starting intensity of each subsequent ramp also increases.

So you’re not simply repeating the same eight-minute progression three times.

The entire workout is gradually moving upwards.

How the Three Ramps Differ

Ramp #1 — Build Towards Threshold

Your first ramp progresses:

Level III → Level III+ → Level IV- → Level IV

This introduces the format while you’re still relatively fresh.

Don’t make the mistake of assuming that means it should feel easy. Instead, use this first ramp to establish good execution.

Ramp #2 — Move the Whole Range Up

Now you progress:

Level III+ → Level IV- → Level IV → Level IV+

Everything has moved upwards by one step.

You’ve also already completed eight minutes of quality work, so you’ll begin to notice the accumulating fatigue.

Ramp #3 — Finish Above Threshold

The final progression is:

Level IV- → Level IV → Level IV+ → Level V-

This is where the workout really comes together.

You start close to threshold, reach it, move above it and then finish with two minutes at Level V-.

Those final two minutes should be challenging.

But if you’ve controlled the previous ramps properly, they should still be achievable.

What You Should Focus On

The most important thing is to respect each intensity Level.

Don’t ride Level III as Level III+ simply because you’re feeling good.

Don’t turn Level IV- into Level IV.

And don’t attack the first ramp because your legs are fresh.

The progression itself creates the difficulty.

During each two-minute stage, establish the prescribed intensity promptly and settle into it.

As you approach the transition, continue riding at the current intensity until it’s actually time to increase the power.

Then make a controlled change.

Think:

Increase → settle → increase → settle.

If you’re riding with power, your data should ideally show a staircase pattern rather than a series of spikes and corrections.

Common Mistakes to Avoid

Starting the first ramp too hard.
There is no need to get ahead of the workout. You have three progressively harder ramps ahead of you.

Anticipating the next intensity.
Don’t gradually increase your power during the final 20 or 30 seconds of each stage. Hold the prescribed Level until the transition.

Surging during the transitions.
You’re looking for a controlled increase in power rather than a five-second acceleration followed by a correction.

Riding the Rest Intervals too hard.
Those two five-minute periods at Level I are genuine recovery. Use them. The next ramp begins harder than the previous one.

Treating the ramps as three identical repetitions.
They’re deliberately different. Each ramp shifts the entire intensity range upwards.

Coach Ray’s Tips

1. Think in Two-Minute Blocks

Rather than worrying about the entire eight-minute ramp, concentrate on executing the current two-minute stage correctly.

Hit the right intensity.

Hold it.

Then move up.

2. Let the Workout Become Hard

You don’t need to manufacture additional difficulty during Ramp #1.

The workout has already taken care of that for you.

Each ramp gets progressively harder, and the intensity also increases four times within each ramp.

Be patient.

3. Make the Transitions Clean

This is one of the most useful technical aspects of the workout.

Practise changing intensity without producing an unnecessary power spike.

Move to the next target, establish the power and settle.

4. Take the Level I Recovery

You have five minutes of Level I riding between Ramp #1 and Ramp #2, and another five minutes between Ramp #2 and Ramp #3.

Use them.

Recovering properly allows you to produce better-quality work during the progressively harder ramps.

5. Save Something for Ramp #3

Your final eight minutes are:

Level IV- → Level IV → Level IV+ → Level V-.

If you’ve paced the first two ramps appropriately, you’ll reach the final ramp fatigued but still capable of completing the progression.

That’s exactly where you want to be.

Who Is This Workout For?

This session is well suited to cyclists and triathletes wanting to develop their ability to work around threshold while responding to progressively increasing demands.

I particularly like it for athletes who are comfortable holding one steady intensity but find changing power while already working hard more difficult.

That’s relevant to plenty of real-world cycling situations.

A climb gets steeper.

The pace of a group increases.

A headwind becomes stronger.

You reach a section of the course where maintaining speed suddenly requires more power.

Rather than simply riding at one constant intensity, you’re learning to respond to an increasing demand while already under load.

Coach Ray Rode This Session

I’ve also completed No Limits Bike Intensity Session I myself.

When I add my data here, one of the first things I’ll examine is whether my power trace reflects the intended progression.

Ideally, the three main efforts should show three distinct staircase patterns.

I’ll look at whether I:

  • established each new intensity cleanly;
  • avoided unnecessary power spikes during the transitions;
  • maintained power throughout each two-minute stage;
  • recovered effectively during the two Level I Rest Intervals;
  • maintained a controlled cadence as the intensity increased; and
  • still produced the prescribed Level V- power during the final two minutes.

Heart rate will provide another useful comparison.

Unlike power, heart rate won’t instantly jump when the intensity changes. I would expect it to progressively respond across each eight-minute ramp, with the cardiovascular demand becoming increasingly apparent as the workout progresses.

See My Complete Ride on Strava

Ride No Limits Bike Intensity Session I on Velocity

Want to put this workout into practice without having to watch the clock and manage every change in intensity yourself?

You can ride No Limits Bike Intensity Session I with me on Velocity.

I’ll guide you through the complete session as the three progressive ramps build from Level III through to Level V-, helping you concentrate on what matters: hitting the correct intensity, making clean transitions and controlling your effort as each ramp gets progressively harder.

Ride the complete workout on demand here:

Not a Velocity member yet? You can start with a 14-day free trial and get access to the coach-led workout library as well as the live Velocity sessions.

Build the intensity. Control the power. Let me coach you through it.

Final Thoughts

No Limits Bike Intensity Session I demonstrates how a relatively simple structure can create a challenging threshold-focused workout.

Every two minutes, the intensity increases.

After the first two ramps, you get five minutes at Level I to recover.

Then you begin again—but from a higher starting point.

The biggest mistake is trying to get ahead of the workout.

Respect the early intensities. Make each transition clean. Recover properly between the ramps. Then allow the progression to gradually create the difficulty for you.

Do that well and the final progression from Level IV- through to Level V- will provide all the challenge you need.

Build the intensity. Control the power. Finish above threshold.

If you know another cyclist or triathlete who would benefit from this workout, share the article with them so they can give it a go too.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.